Menu
The ToolTechnologyApplicationsMaterialsGuidesLearnSupport

Powered suction × SDS rotary hammer

The drill that holds itself.

Anchor to the surface with up to 45 kgf of vacuum force, then drill straight, repeatable holes up to 145 mm deep — without bracing the tool.

Explore VACDRILL Watch the full demo
45 kgfHolding force
145 mmMaximum depth
40 mmMaximum SDS bit
20 VCordless platform

Self-anchoring. Self-driving.

Let the vacdrill carry the job.

Conventional hard-material drilling makes the operator supply feed pressure, resist hammer recoil and hold the bit square — often overhead or from a ladder. The VACDRILL replaces that physical contest with a powered vacuum base and a guided drill column.

Switch on the pump and the sealed pad clamps the system to the surface. Once anchored, the SDS rotary hammer advances on a fixed axis for a straight, repeatable hole.

See the engineering
GRABO VACDRILL anchored to a vertical wall while an electrician works beside it
On the wallThe operator guides. The machine holds.
01 / Accuracy

Fixed axis

The guide column holds the bit square so it cannot wander under load.

02 / Control

Preset depth

Stop at the embedment depth the anchor specification calls for.

03 / Air quality

Dust at source

Connect extraction at the hole before silica dust becomes airborne.

04 / Ergonomics

Less strain

Take repetitive feed force off shoulders, wrists and hands.

One integrated system

Designed around the hole, not the operator.

Vacuum anchoring, guided feed, depth control and dust collection work together. The result is a cordless drilling platform built for repeatability.

VACDRILL precision depth setting in use on a concrete surface
01 / RepeatabilityPreset depth. The same clean hole, again.
Close view of the VACDRILL cordless drive and guide column
02 / Cordless20 V power, no tether.
Side view of the VACDRILL integrated vacuum base and rotary hammer
03 / IntegratedAnchor and drill as one machine.

Every angle

Built as one system.

View full specifications
Front three-quarter view of the GRABO VACDRILL Guided feed
VACDRILL product system with battery and extraction port Integrated vacuum base
VACDRILL standing on a concrete sample in a GRABO workshop display Built for hard materials

From setup to release

Four moves. One precise hole.

A repeatable workflow for the trades that drill all day.

Drill your first hole

Position

Set the bit on the mark and square the base to the surface.

Anchor

Start the vacuum pump and confirm a stable seal before drilling.

Drill

Let the guided feed advance the SDS bit to the preset depth.

Release

Retract the bit, stop the drill, then release the vacuum seal.

Trade 01 Concrete contractorsAnchor patterns, dowels and repeatable embedment. Trade 02 ElectriciansConduit, strut and overhead fixing from a ladder. Trade 03 HVAC installersThreaded rod, hangers and duct supports. Trade 04 Maintenance crewsControlled drilling in occupied spaces.

See the complete cycle

Watch the full demo with sound.

The lightweight silent cut above keeps the homepage fast. The original demonstration here shows the attachment, guided feed and automatic drilling sequence in full.

More from GRABO on YouTube

The background version is self-hosted, silent and optimized for the device. This player loads only when you reach the full demonstration.

Less strain. More precision.

Ready to stop fighting the drill?

Explore the system, check material compatibility and compare the published specifications before choosing your configuration.

Find where to buy